pv module

The PV module when exposed to sunlight generate high voltage and are dangerous.

在阳光照射下组件产生高电压有危险。

This paper presents a kind of SVM for the prediction and simulation of the voltage of the maximum power output in PV module.

根据光伏组件的特点和最大功率点工作电压的影响因素，建立了支持向量机的最大功率点工作电压预测模型。

This paper introduces how to choose the PV module, the light source, the energy storage equipment and how to design the controller and the whole system, and I hope it will g.

本文介绍了光伏组件的配置、光源的选择、储能装置的选用、控制器的设计以及整个系统的设计方法，希望能给读者以参考。

In this system, pv module and inverter are integrated together as an AC PV module, and the AC modules are connected in parallel with the grid.

在这种系统中，光伏模块与逆变器集成在一起，形成一个交流光伏模块，将所有模块输出并联在一起接入电网。

The maximum power point of the PV module is tracked by controlling the input voltage of push-pull converter.

通过控制推挽变换器输入电压使之稳定在太阳能电池最大功率点电压，达到最大功率点追踪目的。

Further more, the voltage curve of shaded cell changing with PV module operation voltage has been gotten.

在此基础上进一步得到被遮挡单体光伏电池电压随光伏组件工作电压的变化曲线。

Reliability Research of Design and Manufacture for Crystalline Silicon PV Module

晶体硅光伏组件设计制造的可靠性研究

Characteristics of partially shadowed serial PV module output

被部分遮挡的串联光伏组件输出特性

To evaluate PV module performance under actual illumination and temperature operating conditions over the course of a day, V-I characteristics of PV module, operating temperature, ambient temperature and solar radiation were measured.

为了研究在户外工作条件下太阳电池组件的实际工作性能，在一天过程中的太阳电池组件V-I特性、组件温度、环境温度和太阳辐照度被测试。

Working in the discontinuous mode of the capacitive/ inductive current, the Buck-Boost converter can realize the maximum power point track ( MPPT) of the PV module without loss.

Buck-Boost变换器工作在电感电流断续模式，由它来实现光伏模块的最大功率点跟踪；

Third, the building photovoltaic grid control strategy has been discussed and PV module model, DC-DC converter and the inverter simulation model has been established.

再后，对建筑光伏的并网控制的控制策略做了探讨并建立了光伏组件模型，DC-DC变换器和逆变器模型，在并网的情况下进行仿真。

Cover the front surface of the PV module by an opaque cloth or other material when repairing.

注意维修时将组件表面用布或其他材料覆盖。

A research of hot spot on PV module with Pspice

基于Pspice的光伏组件热斑现象仿真

AC PV module are defined that the single PV module and inverter are integrated together to constitute a photovoltaic power generation system which can connect directly with the load or grid.

交流光伏模块（ACM，AC Photovoltaic Module），是指将单个光伏组件与逆变器集成在一起，构成一个可直接与负载或电网连接的独立光伏发电模块。

Crystalline Si PV module ⅰ-ⅴ characteristics site measurement and its temperature and irradiance corrections

晶体硅光伏组件实测Ⅰ-Ⅴ特性与温度和辐照度修正

The results show that the variance of PV cells in one module will bring some bad effects, not only causes mismatch losses but also short circuit, and makes the module out of work.

结果表明组件中电池参数不一致将会造成很坏的影响，不仅会造成失配损失，严重时还可以造成组件的短路，使组件停止工作。

Set up calculating model of tilted surface radiation, electrical quantity form pv module and wind turbine;

提出了倾斜面太阳辐射量、太阳能电池发电量、风力机发电量、蓄电池容量的计算方法和计算模型。

The thermal character of PV module encapsulated with insulating glass

中空玻璃式太阳电池组件的热性能研究

The Evaluation of Using Peak Hour Method To Calculate The Output of PV Module

使用峰值小时数的方法估算光伏组件输出的评价

Micro PV inverter module can Plug and Play, so it can be widely used in various small and medium power Photovoltaic power generation fields.

微型光伏逆变器模块即插即用，可以广泛应用于各种中小功率光伏发电领域。

Solar radiation spectrum also has a little influence on output performance of PV module, while solar intensity is mostly diffuse skylight, the PV module has a higher efficiency.

太阳光谱对太阳电池组件的输出性能也有一定的影响，当辐照主要以散射为主时，太阳电池组件有更高的转化效率。夕少了动君己己pv。

It is proposed that the area of PV/ T module, the tilt angel of PV/ T module and the distance of refrigerant pipes are the three key factors of the PV/ T-SAHP system optimization design.

系统PV/T蒸发器的面积、管间距、倾角等参数的变化对电效率和热性能会产生比较大的影响，是系统优化设计的关键因素。

The Austrian company has a special tempering system for thin glass as well as a turnkey PV module encapsulation line among its offerings to the industry.

这家澳大利亚公司拥有专业的薄玻璃回火系统，同时具有一体化光伏组件封装生产线等多种面向这个产业的产品。

Numerical Simulation on the Natural Convection Cooling of PV Module and Hybrid PV/ T Solar System

太阳电池组件自然通风冷却和电热联用的数值模拟研究

In this paper we have studied the main field failure factors of crystalline silicon PV module, propose relevant methods in design and manufacture process, in order to improve reliability of crystalline silicon PV module.

本文分析研究了晶体硅光伏组件野外应用中主要失效因素，提出在设计制造过程中采取相应的措施，以提高晶体硅光伏组件的可靠性。

The Cause Analysis and Optimum Procedure of Power Degradation of Polysilicon PV Module

多晶硅光伏组件功率衰减的原因分析以及优化措施